Fog Lamps; Rear Tail, Turn Signal And Backup Lamps; License Lamps; Center High-Mounted Stoplamp - Jeep 2014 Patriot Owner's Manual

Hide thumbs Also See for 2014 Patriot:

Table of Contents

494 MAINTAINING YOUR VEHICLE

Fog Lamps

1. Access lamp through the lower fascia cutout.

2. Remove electrical connector from bulb.

3. Remove bulb from housing.

Do not touch the new bulb with your fingers. Oil

contamination will severely shorten bulb life. If the

bulb comes in contact with any oily surface, clean the

bulb with rubbing alcohol.

1. Raise the liftgate.

2. Remove the two push-pins from the taillamp housing.

3. Grasp the taillamp and pull firmly to disengage the

light from the aperture panel.

4. Twist and remove socket from the light.

5. Remove bulb from socket and replace.

1. Use a screw driver to gently pry against the side of the

snap tab to remove the lamp from the liftgate.

2. Rotate the socket 1/4 turn counterclockwise.

3. Pull the bulb from the socket.

This light is an LED assembly. See your authorized dealer

for replacement.

Table of Contents