Advertisement
If the LED is flashing three times...pause...three times...pause...etc., then
an intrusion attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and
will only be erased when the ignition key is turned on.
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROLSWITCH
The Push-Button LED switch located on the windshield receiver allows you to
temporarily bypass all alarm functions, eliminating the need to hand your trans-
mitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm functions are bypassed, however the remote panic feature and
remote door locks will remain operational. To use the valet mode, the system
must first be disarmed either by using your keychain transmitter, or by activating
your personalized manual override code.
1.
Enter the vehicle, and turn the ignition key to the on position.
2.
Press and hold the Push-Button switch until the LED turns on solid. The
system will enter and remain in the valet mode.
3.
To return to normal operation, press and release the Push-Button switch
any time the ignition is on.
NOTE: Always remember to return the vehicle to the valet off position. This will
ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
Using The Receivers Push-Button Override Switch
Your Security System can be disarmed without the use of the keychain transmit-
ter. This is necessary, since you will need the ability to operate your vehicle if the
transmitter is lost or its battery fails. If your system has been selected for Valet
Switch manual override as indicated on the last page of this manual, to bypass
the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and release the push-button override switch.
The alarm system will stop sounding and enter the (bypassed) mode. You can
now start and operate the vehicle normally.
Typically this override mode is used only if the transmitter has become
inoperative.
7
128-8803b
7 of 20
Advertisement
