Adjusting Table Insert; Miter Gage Operation And Adjustment - Delta UNISAW 34-801 Instruction Manual

ADJUSTING TABLE INSERT

Place a straight edge (B) across the table at both ends of
the table insert as shown in Fig. 46. The table insert (A)
should always be level with the table. If an adjustment is
necessary, turn the adjusting screws (C), as needed, with
allen wrench supplied. NOTE: THE MITER GAGE
HANDLE CAN BE USED TO STORE THE ALLEN
WRENCHES WHEN NOT IN USE. REMOVE THE TOP
CAP OF THE MITER GAGE HANDLE FOR THE ALLEN
WRENCH STORAGE COMPARTMENT.
MITER GAGE OPERATION
AND ADJUSTMENT
Insert the miter gage bar into the miter gage slot and
assemble the washer and lock handle (A) Fig. 47, to the
miter gage bar as shown.
The miter gage is equipped with adjustable index stops at
90 degrees and 45 degrees right and left. Adjustment to
the index stops can be made by tightening or loosening
the three adjusting screws (B) Fig. 48, with allen wrench
supplied.
To rotate the miter gage, loosen lock knob (A) Fig. 48, and
move the body of the miter gage (C), to the desired angle.
The miter gage body will stop at 90 degrees and 45
degrees both right and left. To rotate the miter gage body
past these points, the stop link (D) Fig. 48, must be
moved up and out of the way.
The head of the miter gage pivots on a special tapered
screw (G) that fastens the head to the miter gage bar. If
the miter gage head does not pivot freely, or pivots too
freely, it can be adjusted by loosening set screw (H) Fig.
49, and turning the screw (G) in or out. Be certain to
tighten screw (H) after adjustment is made. Your miter
gage is equipped with a plate (E) Fig. 49, which fits into
the T-Slot groove in the table. This allows the miter gage
to be pulled off the front edge of the table without falling.
This allows for a longer cut off capacity in front of the
blade.
A
C
16
B
C
A
C
Fig. 46
Fig. 47
A
B
D
Fig. 48
Fig. 49
B