Table of Contents
Advertisement
The printer allows printing out information about its system configuration. These pages can be selected via the
printer panel (Item: INFORMATION MENU).
Note:
The informations for the Configuration Page are recorded at power-up time. There is no update of the
changes after power-up.
Configuration Page (Sample printout on page 23)
This page will be printed via the printer panel (INFORMATION - PRINT CONFIGURATION, or enter "22" on the
numeric keypad. Of particular interest are the indications under Paper Trays and Options and Event Log:
Paper Trays and Options
Event Log
Menu Map (Sample printout on page 24)
The Menu Map page can be selected via the printer panel (INFORMATION - PRINT MENU MAP, or enter "21" on
the numeric keypad). This page is showing on page 1 (and 2), item 3 PAPER HANDLING the different paper
sources and its allocated Media Types (TRAY x SIZE = ... and TRAY x TYPE = ...).
PAPER HANDLING
Paper Path Test
(Sample printout on page 25)
The printer's paper path test allows to perform feeding tests from the different input trays to the output bin(s). It can
be selected via the printer panel (CONFIGURE DEVICE – DIAGNOSTICS – SET PAPER PATH TEST) where you
can set Source, Destination, Duplex and Copies before releasing the printing of the Test Page. The printout shows
all the available input trays with their respective paper sizes and the output bins of the system.
Event Log
You can also print the Event Log (CONFIGURE DEVICE – DIAGNOSTICS – PRINT EVENT LOG). It shows the
last 50 system errors (the Configuration Page only shows the last 3 errors occurred. Very helpful for diagnosing
purposes! (The error codes for TowerFeed and their meaning are indicated above (see Configuration Page).
Note:
Whenever calling for service, please make sure you have these information pages at hand.
IU 675 / 0150
APPENDIX F – Printer Information Pages
- Device 1:
RUTISHAUSER TOWERFEED option with configuration,
Firmware Revision of Option PCB/Logic PCB,
installed trays with tray capacity (80 g/m2 paper)
shows the last three system errors, incl. TowerFeed errors.
TF Error Codes 13.11.xx
TowerFeed Motor blocked
TowerFeed Paper Jam
Tray opened while feeding
** Number of TowerFeed tray (not printer tray) which fed the last sheet
showing paper sources (trays) with SIZE and paper TYPE, e.g.
TRAY 4 SIZE = A4
TRAY 4 TYPE = PREPRINTED
23
1**
2**
3**
4**
.15
.16
.17
.18
.1F
.20
.21
.22
.29
.2A
.2B
.2C
TM
TowerFeed
for the HP LaserJet 9000
5**
6**
.19
.1A
.23
.24
.2D
.2E
Advertisement
Table of Contents
