Vax V-044B Series Instruction Manual page 7

Blower/Inflator Accessories
Fig.7 shows two typical arrangements of accessories to
carry out either blowing or inflation. For increased
flexibility in blowing, it is also possible to fit the tubes to
the end of the hose.
Fig.7
Blower
To attach the blowing adapter, open the rear door by
pulling on the top recess as shown in Fig.8.
Fig.8
Insert the flexible grey inflator hose 9 into the
opening as shown in Fig.9.
Fig.9
Fit the inflation adapter on to the hose, aligning the tab
on the adapter with the hole in the hose adapter as
shown in Fig.10.
Fig.10
Push adapter in direction of arrow until it clicks.
To remove, lift the tab up and pull off the adapter.
During inflation, control the airflow and pressure by
covering the air bypass hole with a thumb as shown in
Fig.11.
Fig. 11
NOTE: Ensure that the flexible hose is clean inside
before inflation.
CAUTION: Do not permanently cover the air bypass
hole.
CAUTION: Unplug the vacuum cleaner before
performing any maintenance.
WARNING: The air holes on the inflation adapter
serve to prevent the object being inflated from
bursting under the high inflation pressure. Ensure that
these holes are never blocked.
7