Viewing A Signal - Agilent Technologies E4440A Getting Started Manual

Viewing a Signal

1. Press . If the softkeys
Preset
.
Factory Preset
2. Press ,
System Reference
press the softkey to toggle the reference on.
3. Connect the analyzer's rear panel 10 MHz OUT (SWITCHED) to the front-panel input.
Setting Reference Level and Center Frequency
NOTE The display examples in this section are made using various analyzer
models, you may see some variations depending upon your analyzer.
4. Set the reference level to 10 dBm: Press
5. Set the center frequency to 30 MHz: Press
The 10 MHz reference signal spectrum appears on the display, as shown in
Figure 3-1.
The display examples in this book are made using various analyzer
NOTE
models, you may see some variations depending upon your analyzer.
Chapter 3
and
Factory Preset
, then note the
10MHz Out
AMPLITUDE
FREQUENCY
Making a Basic Measurement
appear, select
User Preset
setting. If is active (underlined),
Off
, .
10, dBm
,
Center Freq
Viewing a Signal
, , .
30 MHz
37