Viewing A Signal - Agilent Technologies E4401B Getting Started Manual

Viewing a Signal

1. Press . If the softkeys
Preset
.
Factory Preset
2. Connect the analyzer's rear panel 10 MHz REF OUT to the front-panel input.
Setting Reference Level and Center Frequency
NOTE The display examples in this section are made using various analyzer
models, you may see some variations depending upon your analyzer.
3. Set the reference level to 10 dBm: Press
4. Set the center frequency to 30 MHz: Press
The 10 MHz reference signal spectrum appears on the display, as shown in
Figure 3-1.
NOTE The display examples in this book are made using various analyzer
models, you may see some variations depending upon your analyzer.
Chapter 3
and
Factory Preset User Preset
AMPLITUDE
FREQUENCY
Making a Basic Measurement
appear, select
, .
10, dBm
, , ,
Center Freq 30 MHz
Viewing a Signal
.
45