Daewoo DVN-14F6N Service Manual page 37

3-2) COLOR NOISE REDUCTION
Mode Adjustment parts
EE RY 91
Location of Adjustment Parts
Y/C PCB
PY05
RY91
IY03 IY01
PAY01
Y/C PCB SOLDER SIDE
• Adjustment Procedure
1. Preparation
1) Supply the Color bar signal to the VIDEO LINE IN JACK.
2) Supply 5V to RY05.
2. Adjustment
1) Set the VCR to the STOP(EE) Mode.
2) Set the Oscilloscope to the chop mode.
Connect CH1 to the V-OUT(RY09) and CH2 to the YNR TP (RY05) and trigger the scope with the signal from CH1.
3) Adjust RY91 until Color signal becomes minimum.
Check point
PY09
PY09
IY02
PAY02
Test equipments
Signal gen.
Oscilloscope
Observation Waveform
Horizontal Axis : 10µS/DIV
Vertical Axis : 50 mV/DIV
34
Test tape Input signal
Color Bar
CH-2(PY09(NR)
Horizontal:10µs/DIV
Vertical:50mv/DIV