Daewoo DVN-14F6N Service Manual page 19

Fig. 27- Tension Band Assem-
bly Removal (2)
Capstan Motor Removal
Remove three (3) screws and remove the capstan motor.
Fig. 29-Capstan Motor Removal
Idier Plate/Reel Table Removal
1. Remove one polywasher
and remove the idier plate
2. Remove the reel tables
from the deck mechanism.
Fig. 30- Idler Hate/Reel Table Removal
Fig. 28- Tension Band Assem-
bly Alignment With
Main Base
(Fig. 29)
(fig. 30)
from the idler plate
from the main base.
and the two polysliders
FE Head Removal
Remove one (1) screw (1) and lift the FE head (2) from the
main base.
Fig. 31- FE Head Removal
Reel Gear Total Ass'y and Connect Plate
Removal
(fig. 32)
1. Turn the deck mechanism upside down and remove one
polywasher .
2. Release the tab "B" of the main base and part the reel
gear total ass'y
3. Push the connect plate
rate it from the main base.
NOTE :
• When removing the connect plat with the the F/L rack
installed, take care not to damage/bend the connect plate.
• When assembling or disassembling, take care not to get
oil or grease on the reel belt.
Fig. 32- Reel gear total ass'y and Connect Plate Removal
16
(fig. 31)
from the main base.
to the left direction and sepa-