Installing The Batteries - Targus Stow-n-go User Manual

Targus Wireless Stow-N-Go Laptop Mouse with Micro USB Receiver
TM

Installing the Batteries

1. Remove the battery cover from the back of the mouse by sliding off
the cover of the mouse. Hold the mouse in your hands and with the
back of the mouse away from you. Press down on the corners of
the battery cover and slide towards the back of the mouse. Lift the
cover off from the back of the mouse.
2. Insert two AA-size batteries, making sure that the positive (+) and
negative (-) ends of each battery match the polarity indicators
inside the battery compartment. To replace the battery cover,
place the cover on top of the mouse and slide forward until it clicks
into place.
4
Targus Wireless Stow-N-Go Laptop Mouse with Micro USB Receiver
TM
Establishing the Connection
(A) Remove the USB receiver from the bottom of the mouse.
(B) Plug the USB receiver into an available USB port on your com-
puter.
This mouse is a plug-n-play device. It should automatically operate
when the USB receiver is connected to the computer.
5