Advertisement
Quick Links
QUINCE™
SINGLE CONTROL KITCHEN
FAUCET WITH CAST SPOUT
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Recommended tools
Regular Screwdriver
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
Make certain the SEAL (9) is properly seated in recess of spout base.
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).
Insert supply HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface.
Follow mounting instructions below to secure faucet to mounting surface.
(B)
Installation less ESCUTCHEON (1).
mounting surface. Do not use putty.
Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening
the screws slightly each time until all are snug to ensure even pressure.
A
9
1
P U T T Y
Phillips Screwdriver
Insert all HOSES (2) and SHANK (3) through MOUNTING RING (10) and
7
2
3
4
5
8
6
Installation
Instructions
4433.001
Adjustable Wrench
CAUTION
B
10
9
3
2
S I N K O R
M O U N T I N G
S U R FA C E
8
Certified to comply with ANSI A112.18.1M
M 9 6 5 115 _ R ev. 1. 2
Plumbers' Putty or Caulking
Turn off hot and cold water
supplies before beginning.
7
4
5
6
Advertisement
Related Manuals for American Standard QUINCE 4433.001
Summary of Contents for American Standard QUINCE 4433.001
- Page 1 QUINCE™ SINGLE CONTROL KITCHEN FAUCET WITH CAST SPOUT Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin. Recommended tools Regular Screwdriver INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON Make certain the SEAL (9) is properly seated in recess of spout base.
- Page 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Line) and right supply to Cold wall supply. Use adjustable wrench to tighten connections.
- Page 3 SERVICE Reduced flow. If the flow gradually reduces over a number of months, the AERATOR (12) may have collected debris. To clean, remove AERATOR (12) and rinse with water and remove any debris. Turn on faucet to wash any debris out of the faucet.