Diagnostic Tests; Checking The Date And Time Using The Back-Up Battery; Checking The Power On "Selfandkeytest - Kodak EasyShare C140 Service Manual

Diagnostic Tests

Checking the Date and Time Using the BACK-UP BATTERY

[1] Insert RECHARGEABLE BATTERIES with a full charge into the CAMERA to apply 3.7 V to the BACK-UP
BATTERY or STORAGE CAPACITOR.
[2] Energize the CAMERA.
[3] Set the correct date and time.
[4] De-energize the CAMERA.
[5] Wait a minimum of 24 hours.
[6] Remove the RECHARGEABLE BATTERIES for more than 10 minutes.
[7] Insert the RECHARGEABLE BATTERIES into the CAMERA.
[8] Energize the CAMERA.
[9] Check the date and time.
Note
The date and time must be correct within 30 seconds.

Checking the Power On "SelfAndKeytest"

[1] Do "Preparing the "C140 Self_Test" MEMORY CARD" on Page
[2] Insert into the CAMERA:
• BATTERIES with a full charge
• "C140_Self_Test" MEMORY CARD
[3] Energize the CAMERA to execute the test.
[4] If the LCD displays "Set Date & Time", select "Cancel".
[5] Check:
• LCD displays "Script Loading..."
• results of each of the following tests
Test
RBG and gray levels
"LED testing"
"LCD testing"
"Flash testing"
"SDRAM testing"
"LCD Bad pixel testing"
"Temperature Sensor testing"
SWITCHES
[6] When the test is completed, follow the prompt to press the "OK" BUTTON.
[7] De-energize the CAMERA.
[8] Remove the MEMORY CARD.
SM8720-1 – 15APR10
The quality of the 6 colors and the 6 gray areas
The red LED on the front of the CAMERA illuminates.
LCD blinks
STROBE energizes once
"OK" displays
LCD for:
• dark pixels in the white screen
• white pixels in the dark screen
"OK" displays
The names of the SWITCHES display on the LCD. Press each
SWITCH. A green "O" displays for each successful test.
64.
Check:
Diagnostics
21