Fujitsu PRIMERGY TX200 S3 Start Manual

PRIMERGY TX200 S3 Manuals
n
Manuals for this server can be accessed from the section below of the PRIMERGY Document & Tool CD.
[CD-ROM Drive] :\MANUAL\INDEX.PDF
Manuals can be displayed using Acrobat
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, contact an office listed
in the "Contact Information".
3
Installing internal options
If internal options have been purchased separately, install them before installing the operating system.
In the following case, it is not required to install the internal options.
- Custom Made Service
n Point to note before installing internal
options
When installing internal options, perform operations after
reading the following manuals.
"Chapter 7 Installing Internal Options"
"PRIMERGY Server Books"/"Supplement"
Install the OS before installing the following options.
Installing the OS after options have been installed will
cause installation operations to end in an error.
- Non-system hard disks
- External SCSI optional devices (Backup cabinet, DAT
unit , etc.)
TX200 S3
Reader or Adobe Reader
® ® ®
1
. If using Acrobat Reader , use version 5.0 or later.
® ® ®
2
Reading and understand-
ing "Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
Also check it when connecting, installing internal options
and setting up this server.
n Available Internal options and
installation locations
�������������� ���
���������������
After installing internal options, check that the order and
place of installation is correct and cables are correctly at-
tached.
B7FH-4311-01EN-00
������������������
������������������������
��������������������
�������������������������