Fujitsu Primergy TX200 S2 Start Manual page 5

8
Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation, such as UPS device.
������������ "Chapter 7 Installing Hardware Options"
1
Check that no medium is inserted in the
floppy disk drive or CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is au-
tomatically turned off.
When the power of the server is not off after the OS
is exited, press the power switch on the front of the
server.
3
Turn off the power supply of the periph-
eral devices, such as the display.
4
Install the optional devices.
9
Hints for error handling
In preparation of a failure occurring, set the following:
������������ "Chapter 5 Operations after OS Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is automatically saved when the STOP error occurs in the system.
This helps to analyze the cause of error occurrence.
- Create a system restoration disk
When the system file or system environments are damaged, the system can be reconstructed with the content saved in the sys-
tem restoration disk.
- Store system settings
By storing the BIOS settings, the original information can be recovered when the setting information is lost.
When this server is installed, store and save the BIOS settings by yourself.
Be careful not to lose the stored BIOS setting information as you must provide this when you contact the
When the settings are completed, make sure to check notes before operation.
������������ "5.5 Notes Before Operating the Server"
For details about maintenance after operations have started, refer to "User's Guide Chapter 9 Operating and
Maintenance".
After optional devices are installed, set the BIOS
setup utility or SCSI setup utility as required.
For details about setting procedures, refer to the
"User's Guide Chapter 8 Configuring Hardware and
Utilities".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, and error will occur that may be cause damage.
5
" Contact Information " .