Advertisement
Using Your Oil Column Heater
Before First Use
Remove any promotional material or
packaging from the heater.
The oil heater requires a small amount
of assembly before use.
Assembling Your Heater
NOTE: Before operation,
please make sure that the
castor wheels have been
correctly fitted to the castor
wheel mounting plate (for
KOH105, KOH105B and KOH107
only) and the castor wheel
mounting plate is securely
fitted to the body of the oil
heater (all models).
Castor Wheel Assembly
(KOH105, KOH105B, KOH107)
1.
Unpack the castor wheels from
the packaging and remove the
nut, spring washer and flat washer
from the castor wheel shaft.
2. Unpack the castor wheel
mounting plate from the
packaging. Feed the castor
wheel shaft upwards through the
underside of the castor wheel
mounting plate, and align the
rectangular locator on the base
of the castor wheel shaft with the
slot on the mounting plate. The
castor wheel shaft and mounting
plate should fit together snuggly.
3.
Replace the flat washer and
spring washer back on to the
castor wheel shaft, over the top of
the mounting bracket and secure
tightly with the nut provided. The
nut may need to be tightened
with a spanner (Fig.1).
8
Fig. 1
Mounting Bracket Assembly
(all models)
NOTE: Always secure the
mounting plate between the
last two fins at each end of the
oil heater (Fig.2).
NOTE: Make sure that the castor
wheels are positioned away
from the centre of the heater to
provide greater stability (Fig.2).
Fig. 2
1.
Place the radiator body upside
down on a soft surface to avoid
damage to the heater. Make sure
it is in a stable position and will
not fall.
2. Place the mounting plate onto the
base of the oil heater, between
the last two fins at each end.
3.
Remove the wing nuts provided
from the U bolt assembly.
4. Hook the U bolt around the body
section, joining the last two fins,
and feed each end back up
through the top of the mounting
plate. Secure the U bolt to the
mounting plate with the plastic
wing nut provided.
5. Repeat at the other end of
the heater.
6. Return the unit to an upright
position, and it is now ready for use.
Turning Your Heater On
Always place the heater on a firm,
level surface in a stable upright
position and unwind the cord to its
full length.
Ensure the Heat Setting switches are
switched to 'OFF'.
Plug the cord into a 230V or 240V
power point and switch on.
NOTE: To avoid an electrical
circuit overload, it is
recommended that no other
appliances are plugged into
the same circuit as your heater,
when it is in use.
Setting The Heating Mode
All Kambrook oil heaters operate in
manual heating mode only, except
for the KOH111 and KOH111B models,
which can also operate using the
programmable timer. To operate
using the programmable timer, see
the 'Setting the Programmable Timer'
section.
The oil heater has two switches,
offering three heat settings.
LOW
MED
HIGH
Setting
KOH105/
KOH107
KOH111/
KOH105B
KOH111B
LOW
400W
600W
1000W
MED
600W
900W
1400W
HIGH
1000W
1500W
2400W
9
Advertisement
