Connecting To The Tv; Inserting The Batteries (Aaa X 2) - Samsung 8+ series User Manual

Connecting to the TV

In order to operate the TV using a Smart Touch Control unit, you must fi rst pair it to the TV via Bluetooth. However, the
Smart Touch Control is only available for the paired Samsung TV.
1. When the TV is off, point the Smart Touch Control at the remote control receiver of the TV and press the TV button
for the fi rst pairing. Only this buttons sends an IR signal. The remote control receiver's location may vary depending
on the model.
2. A Bluetooth icon will appear at the bottom left of the screen as shown below. The TV will then attempt to connect
to the Smart Touch Control automatically.
Reconnecting the Smart Touch Control
<The Smart Touch Control's pairing button>
Battery Low Alarm
If the battery becomes and blanks low while using the Smart Touch Control, the following alarm
window blinks and appears at the bottom left of the screen. If the alarm window pops up, replace
the batteries of the Smart Touch Control. Use alkaline batteries for longer usage.

Inserting the Batteries (AAA X 2)

1
1. Slightly lift the battery cover by pulling the strap or using a plastic card (e.g. a credit card). Next, pull on the cover's
notch with a fi ngernail to remove the cover completely.
2. Insert 2 AAA batteries, making sure to align the positive and negative ends correctly.
3. Align the battery cover with the back of the remote control and press down along the edges until it is cleanly
attached to the remote control.
<Attempting to connect and completion icons>
If you need to reestablish the connection between the TV
and the Smart Touch Control, press the pairing button at the
back of the Smart Touch Control toward the Remote receiver
of the TV. The pairing button can be accessed by removing
the Smart Touch Control's battery cover. Pressing the pairing
button automatically reestablishes the connection between
the Smart Touch Control and the TV.
2
English - 7
3