Ryobi EVT350RG Owner's Operating Manual

Ryobi EVT350RG Owner's Operating Manual

Trimming and routing kit

Advertisement

EVT350RG
TRIMMING AND ROUTING KIT
OWNER'S OPERATING MANUAL
ORIGINAL INSTRUCTIONS
1N.
1
/
2
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EVT350RG and is the answer not in the manual?

Questions and answers

Summary of Contents for Ryobi EVT350RG

  • Page 1 EVT350RG TRIMMING AND ROUTING KIT OWNER’S OPERATING MANUAL ORIGINAL INSTRUCTIONS...
  • Page 2 DESCRIPTION 1. On / Off switch 18. Bolt 2. Base 19. Nail 3. External brush cap 20. Bolt A 4. Motor housing 21. Bolt C 5. Collet 22. Bolt B 6. Collet nut 23. Bit 7. Depth of cut scale 24.
  • Page 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9...
  • Page 4 Fig. 10 Fig. 11...
  • Page 5 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifi cations.
  • Page 6 English drugs, alcohol or medication. A moment of inattention GENERAL POWER TOOL SAFETY WARNINGS while operating power tools may result in serious personal injury. WARNING  Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, Read all safety warnings and all instructions.
  • Page 7: Special Safety Rules

    English  Keep cutting tools sharp and clean. Properly  Trimming wood and plastics. maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. ASSEMBLY  Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed.
  • Page 8: Operation

    English  Securely tighten the wing bolt. WARNING If you are changing a cutter immediately after use, be OPERATION careful not to touch the cutter or collet with your hands or fi ngers. They may get burnt due to the heat buildup from cutting.
  • Page 9: Depth Of Cut

    English Tighten the screw to install the adjusting guide on the would affect the normal progress of the cutting action, tool base plate. Loosen the wing bolt to adjust the guide. there will be a slight kickback — suffi cient to spoil the Then tighten the screw fi...
  • Page 10: Proper Care Of Collet

    English when sharpening the end of a cutter to grind the ENVIRONMENTAL PROTECTION Clearance angle the same as originally ground. Recycle raw materials instead of disposing PROPER CARE OF COLLET of as waste. The machine, accessories and packaging should be sorted for From time to time, it also becomes necessary to clean environmental-friendly recycling.
  • Page 12 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 27 Clemow Drive Mt. Wellington, Auckland 1060, New Zealand...

Table of Contents