Software Upgrade - Samsung Crystal Surround Air Track HW-F750 User Manual

flJnctions
- N-
@ ®
auaP1:& siQ&tv~DU~a
DOD @
:·····
....
:
.........
~iG:l!D
;
........
:
CD0CD
8 @8
Using the Anynet+{HDMI-CEC) function
Anynet+ is a function that enables you to control other Samsung Devices
with your Samsung TV's remote control.
The Anynet + function turns on and off each time you press
Any
net+.
1. Connect the product to a Samsung TV with an HDMI cable.
(See page 13)
2. Set the Anynet+ function on your TV and the SAT to ON. (See the
TV instruction manual for more inforrnat1ion.)
• Depending on your
TV,
certain HDMI output resolutions may not work.
• Please refer to the user's manual of your TV and check for the
~D!C
logo (If your TV has an
~
logo, then it supports the
Anynet+ function.)
Using the TV functions {with Samsung TVs only)
• Press TV SOURCE on the remote control to change the TV's input
source.
• Press
TV INFO
on the remote control to display the TV channel
information.
• Press
TV
CH on the remote control to select the TV channel.
• Press TV
VOL
on the remote control to increase or decrease the volume
level.
• Use TV PRE-CH button to move to the previous TV channel in TV mode.
• When you press the
SoundS hare
button, the TV's sound is
transmitted through the Air Track system via a Bluetooth
connection. The Air Track also controls the sound volume,
sound quality, etc.
• The remote control can operate TVs made by SAMSUNG only.
SOFTWARE UPGRADE
Samsung may offer upgrades for the Crystal Surround Air
Track's system firmware in the future.
If an upgrade is offered, you can upgrade the firmware by
connecting a USB drive with the firmware upgrade stored on
it to the USB port on your Air Track.
Note that if there are multiple upgrade files, you must load them
onto the USB drive singly and use them to upgrade the firmware
I
one at a time.
t-===~='""=~F====='\
Please visit Samsung.com or contact the Samsung call center
to receive more information about downloading upgrades files.
22
• lnserit a USB drive containing the firmware upgrade into the USB port on the· main unit.
• Do not disconnect the power or remove the USB drive while upgrades are being applied. The main unit will
turn off automatically after completing the firmware upgrade.
When software is upgraded, settings you have made will return to their default (factory) settings.
We recommend you write down your settings so that you can easily reset them after the upgrade.
• Once upgrading the product software is completed, turn off the product and then press and hold
(• l
button for
a while to reset the product.
• If the firmware fails to upgrade, we recommend formatting the USB device in F AT1 6 and trying again.
• F or upgrading purposes, do not format the USB drive in NTFS format because it is not a supported file system.
• Depending on the manufacturer, some USB devices may not be supported.