Additional Safety Rules - For Belt Sanders - Worx WT661K Manual

3”x18”/7a belt sander

Hide thumbs

Table Of Contents

Table of Contents

Available languages

long hair can be caught in moving parts. Keep handles dry, clean and free from oil and

grease. Rubber gloves and non-skid footwear are recommended when working outdoors.

c) Avoid accidental starting. Be sure switch is "OFF" before plugging in. Carrying

c) Avoid accidental starting. Be sure switch is "OFF" before plugging in.

tools with your ﬁnger on the switch or plugging in tools that have the switch "ON" invites

accidents. Do not use a tool if the power switch does not turn it "ON" and "OFF" .

d) Remove all adjusting keys and wrenches. Make a habit of checking that adjusting keys,

d) Remove all adjusting keys and wrenches.

wrenches, etc. are removed from the tool before turning it "ON" .

e) Do not overreach. Keep proper footing and balance at all times.

e) Do not overreach. Keep proper footing and balance at all times. Proper footing and

balance enable better control of the tool in unexpected situations.

f) Use safety equipment. Always wear eye protection.

f) Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes,

hard hat, or hearing protection may be used for appropriate conditions.

g) Keep hands away from all cutting edges and moving parts.

4. TOOL USE AND CARE

a) Use clamps or other practical way to secure and support the work-piece to a

stable platform. Holding the work by hand or against your body is unstable and may lead

to loss of control.

b) Do not force tool. Use the correct tool for your application. The correct tool will

do the job better and safer at the rate for which it is designed. Excessive force only causes

operator fatigue, increased wear and reduced control.

c) Do not use tool if switch does not turn it "ON" or "OFF". A tool that cannot be

controlled with the switch is dangerous and must be repaired.

d) Disconnect the tool from the power source before making any adjustments,

changing accessories, or storing the tool. Such preventative safety measures reduce

the risk of starting the tool accidentally.

e) Store idle tools out of reach of children and other untrained persons. Tools are

dangerous in the hands of untrained users.

f) Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained

tools, with sharp cutting edges, are less likely to bind and easier to control.

g) Check for misalignment or binding of moving parts, breakage of parts, and any

other condition that may affect the tool's operation. If damaged, have the tool

serviced before using. Many accidents are caused by poorly maintained tools.

h) Use only accessories that are recommended by the manufacturer for your model.

Accessories that may be suitable for one tool may create a risk of injury when used on

another tool.

i) Use the right tool. Do not force the tool or attachment to do a job for which it was not

designed.

5. SERVICE

a) Tool service must be performed only by qualiﬁed repair personnel. Service or

maintenance performed by unqualiﬁed personnel could result in a risk of injury.

b) When servicing a tool, use only identical replacement parts. Follow instructions

in the Maintenance section of this manual. Use of unauthorized parts or failure to

follow Maintenance Instructions may create a risk of electric shock or injury.