Advertisement
Operation of DELTA change-over switch in CARBURETOR mode
GAS position of change-over switch
If the vehicle's ignition is on, the GAS electrovalve is opened for 3 seconds
approxmately. This change-over switch is fitted with a safety device that
closes the GAS electrovalve if the engine stops accidentally. While the GAS
electrovalve is open, the two-colour led is on in a GREEN color.
Switch-over from GAS to PETROL
Position the switch on PETROL. This will open the PETROL electrovalve
while the GAS electrovalve remains open for 4 seconds to allow the
carburetor chamber to be filled in. During these seconds, the two-colour led
blinks in RED and there is a GREEN light on.
Change-over from PETROL to GAS
Position the switch on the NEUTRAL position (central position of switch), so
that the fuel remaining in the carburetor is consumed. The two-colour led
indicates this condition blinking with a RED light, then position the switch on
GAS.
PETROL position of change-over switch
The vehicle runs on PETROL at all times. The two-colour led remains on
showing a RED light
.
8
ENGLISH
Instructions for the Connection and Use of DELTA Electronic Change-over Switch
F1 Electrónica
congratulates you on your purchase of this product.
Through high technology, we offer smaller, more reliable, attractive
and easy to install products.That is why we say:
TECHNOLOGY AT THE SERVICE OF CNG
Description of Change-over Switch Front View
3-position switch
Leds indicating GAS pressure
GAS pressure is indicated through 4 leds. The reserve is indicated through
the ¼ intermitent led.
Operation of DELTA Change-over Switch
THIS CHANGE-OVER SWITCH IS DESIGNED FOR VEHICLES FITTED WITH
ELECTRONIC INJECTION AS WELL AS VEHICLES FITTED WITH
CARBURETOR AND ORIGINAL ELECTRONIC IGNITION, BOTH WITH CNG
EQUIPMENT.
*DEFINITION OF THE OPERATION MODE*
Operation modes are:
1) CARBURETOR mode.
2) DECELERATION INJECTION mode.
3) ACCELERATION INJECTION mode.
ALL DELTA CHANGE-OVER SWITCHES ARE PROVIDED BY
MANUFACTURER IN INJECTION MODE WITH AUTOMATIC CHANGE-
OVER FROM PETROL TO GAS DURING DECELERATION.
Operation modes are established through a JUMPER placed on the printed
circuit board inside the DELTA change-over switch unit, next to the TWO-
Figure 1
COLOUR LED, see
.
.
Two-colour led
Red PETROL
Green GAS
5
ENGLISH
Advertisement
