Advertisement
Exclusions and Limitations:
a) Maintenance, control, repair or replacement of parts that have
deteriorated after normal use.
b) Damage or malfunctioning resulting from wrong installation, misuse or
use that does not agree with the technical instructions supplied, and any
defect that is not caused by a construction defect, and therefore to the
responsibility of F1 Electronica S.R.L.
c) Products installed, repaired, replaced or changed by individuals not
authorized in writing by F1 Electrónica.
d) Accidents caused by force majeure (i.e.: fire, water, electromagnetic
fields, etc.) not controlled by F1 Electrónica.
Serial Nr.:
Vehicle model and brand:
Fitter Stamp:
4
ENGLISH
Date of installation:
[ TO BE PROVIDED TO USER ]
Connection Diagram of DELTA Electronic Change-over Switch
(-)
(+)
03
G
E
02
04
A
06
05
F
07
02
E
References for the connection diagram of DELTA electronic change-over switch
Rear view of DELTA change-over switch.
A
MAX. 5A Fuse
B
Pressure gauge with infrared sensor.
C
D
Connection cables to pressure gauge.
E
Chassis GROUND.
F
PETROL electrovalve (CARBURETOR mode).
G
Ignition coil, or ignition module, or ECU.
H
Gas electrovalve.
+12V under ignition swtich.
J
H
B
J
01
D
C
ORANGE cable (+12V).
01
BLACK cable (GROUND).
02
RED cable,
03
connection to ignition coil
negative, or ignition module signal, or
ignition signal of the ECU, or RPM signal of
the ECU. This signal must have a minimum
amplitude of 5V.
04
BLUE cable.
05
WHITE cable.
06
YELLOW cable.
07
GREEN cable.
ENGLISH
9
Advertisement
