FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a class B product.
CONTENT ............1 Package Contents ......1 Chapter 1. Introduction of the Product Overview of the Product ........1 Convention ............2 Features..............2 ..........3 Chapter 2. Installation Mounting the Switch on a Desk......3 Power On ............... 4 ....4 Chapter 3. Identifying External Components Front Panel ............
Chapter 1. Introduction of the Product Thank you for choosing the TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch. 1.1 Overview of the Product The TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch...
*PD: a device powered by a PSE and thus consumes energy. Examples include powering IP telephones, wireless LAN access points, network cameras, network hubs, embedded computers etc. 1.2 Convention The Switch or TL-SF1008P mentioned in this User Guide stands for TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch without any explanation. 1.3 Features...
LED indicators for monitoring power, link, activity and speed External power adapter supply Chapter 2. Installation During the installation procedure, please only use the accessories equipped with the switch. 2.1 Mounting the Switch on a Desk To install the Switch, please follow the steps: 1) You can place the Switch on a flat desk.
2.2 Power On The TL-SF1008P Switch can be used with DC power supply. Powering on the Switch, it will automatically initialize and its LED indicators will respond as follows: 1) All the LED indicators except PoE ports LED will light syn-...
Page 11
Name Status Indication On(green) Power on. Power Power off. There is a PoE PD connected to On(green) the port, which supply power successfully. The PoE power circuit may be in short, or the power current may PoE ports On(red) over that PD’s (port-1~port-4)
Port 4 because of the overloaded power, this means Port 1, 2 will use 15.4w, and Port3 will use 10w ,no power will be supplied to Port 4. 3.2 Rear Panel Figure 3-2 TL-SF1008P Switch Rear Panel...
Page 13
LEDs on the front panel. Ethernet Ports (1-8): Besides the 4 PoE ports, the TL-SF1008P Switch is also equipped with the other four 10/100Mbps Auto-Negotiation RJ45 ports without PoE function. Once the network devices are connected to these 8 ports through the network cable, the switch will make them plug and play according to the Auto-MDI/MDIX detection.