The Radio Connection To A Network Does Not Work; Acoustic Warnings; Smartcard Reader Is Not Recognized; Smartcard Pin Forgotten - Fujitsu LIFEBOOK E734 Operating Manual

The radio connection to a network does not work

Theradioconnectiontoanetwork does notwork
(Possible) Cause
The wireless component is disabled.
The wireless component is enabled. Despite
this, the wireless connection to a network does
not work.

Acoustic warnings

Acoustic error messages Errors
Cause
A beep sounds every few seconds.
The battery is almost flat.

SmartCard reader is not recognized

Cause
Chip card inserted incorrectly.

SmartCard PIN forgotten

Cause
PIN forgotten

SmartCard lost

Cause
SmartCard lost
Fujitsu
Troubleshooting
► Switch the radio component on (see
"Switching the wireless components on and
off", Page 45).
► Check whether the radio connection is
switched on via the software.
► Further information on using the radio
component can be found in the help files.
Troubleshooting
► Charge the battery.
Troubleshooting
► Make sure you have inserted your
SmartCard into the SmartCard reader with
the chip facing upwards.
► Check whether the SmartCard you are using
is supported. Your SmartCard must comply
with the ISO standard 7816-1, -2, -3 and -4.
Troubleshooting
► If you are working in a network, contact your
system administrator, who can unlock your
notebook with a Supervisor PIN.
Troubleshooting
► If you are working in a network, contact your
system administrator, who can boot up your
notebook with a Supervisor SmartCard.
Troubleshooting and tips
79