Setting The Remote Control Id; Correcting Color When Projecting From Multiple Projectors - Epson EB-D6250 User Manual

Projection Functions
d
Press the [Menu] button to end the setting procedure.

Setting the remote control ID

Set the ID on the remote control each time you switch the projector power
on. When the projector is turned on, the remote control ID is set to "0"
(that is, you can operate the projector with the remote control regardless of
the projector ID).
a
Point the remote control at the remote receiver of the target
projector and press the [ID] button on the remote control.
When you press the ID button, the current Projector ID is displayed
on the projection screen. It disappears in about three seconds.
Remote control
b
While holding the [ID] button, press the number button that
matches the ID of the projector you want to operate.
Once this setting has been made, the projector that can be operated by the remote
control is limited.
a
When you power off the projector, the remote control ID is reset to
"0" (that is, you can operate the projector with the remote control
regardless of the projector ID).
Correcting Color when Projecting from Multiple
Projectors
When multiple projectors are lined up and projecting images, you can
correct the brightness and color tone of each projector's image with multi-
screen color adjustment so that the colors of images from each projector
match closely.
a
In some cases the brightness and color tone may not match completely
even after correction.
53