Energer ENB466PLN Safety And Operating Manual page 12

Fig.5
Fig.6
710W PLANER ENB466PLN
4. Planing (Fig.5)
CAUTION!
Never cut the unsecured workpiece!
The rate of planning and the depth of cut determine the
quality of the finish. For rough cutting, the user can increase
the depth of cutting. However to achieve a good finish you
will need to reduce the depth of cutting and advance the tool
more slowly.
The proper feed rate will depend on the type of material
being cut and the quality requirement of finish. Normally, the
harder material need slower speed.
WARNING
Don't apply big pressure to the machine.
Best cutting results can be obtained by only a slight
pressure on the tool; Forcing and excessive pressure will
damage the blade and cause serious personal injury.
Moving the machine too fast may cause a poor quality of
cutting and can damage the blades or the motor. Moving the
machine too slowly may burn or mar the workpiece.
Incline the workpiece slightly away from user, it may make
planning easily.
5. Chamfering edges (Fig.6)
For chamfering edges use the V-grooves in the base.
Set cutting Depth scale in "0" position and then run the
planer along the corner edge.
Caution!
Always test out first on a piece of scrap material for
chamfering edges.