American Standard TOWN SQUARE 3636.STTS Installation Instructions

Installation Instructions

TOWN SQUARE
ACRYLIC SHOWER BASE
MODELS 3636.STTS, 3838.NEOTS, 4834.STTS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is
installed properly, please read these instructions carefully before you begin. (Certain installations may require professional
help.) Also be sure your installation conforms to local codes.
For alcove (.STTS models) installation only:
The opening dimensions should be 1/8" larger than dimensions shown.
NOTE: Read instructions completely before proceeding with installation.
3838.NEOTS
484mm
(19-1/16)
972mm
(38-1/4)
215mm
(8-7/16)
215mm
(8-7/16)
972mm
(38-1/4)
1
Insure the floor and stud walls
are square and plumb.
Provide a 5" x 5" (127mm x
127mm) opening in the floor
for the drain (see Figs. A & B).
The drain plug accommodates
a 2" (51mm) PVC waste pipe.
The waste pipe should extend
above the surface of the
sub-floor 3/8" ± 1/16".
Note: Variations in levelness
of subfloor may require
adjustment of waste pipe
height. See product drawings
on this page for the specified
drain locations.
4834.STTS
679mm
(26-3/4)
870mm
(34-1/4)
215mm
(8-7/16)
484mm
(19-1/16)
3838 NEOTS
C/L
C/L
90°
51 mm (2)
127mm x 127mm
PVC Waste Pipe
(5 x 5) Opening
A
(See Product Chart for Drain Location)
3636.STTS, 4834.STTS
90°
90°
51 mm (2)
127mm x 127mm
C/L
PVC Waste Pipe
(5 x 5) Opening
B
(See Product Chart for Drain Location)
FRONT
610mm
(24)
1219mm
(48)
2
Before installing drain into
the shower base, remove
strainer (see Fig. C). This
will be installed after
shower base is in its final
position. Install the drain to
the shower base as shown
90°
in Fig. D. Use silicone
sealant between drain
body and shower base.
No Bedding
Under
Apron
Bedding
Material
D
Certified to comply with ANSI Z124.2 1987.
Observe local plumbing and building codes.
3636.STTS
914mm
(36)
215mm
(8-7/16)
DRAIN
ASSEMBLY
Rubber
Caulking
Gasket
Drain
Body
Silicone
Sealant
Rubber
Gasket
C
Waterproof
Drywall
13mm (1/2")
minimum
Bedding Material Area
51 mm (2)
PVC Pipe
127 mm (5)
752769-100 Rev. C
FRONT
457mm
(18)
914mm
(36)
Strainer
Shower
Base
Fiber
Gasket
Locking
Nut
3 mm
(1/8)
51 x 102 mm
(2 x 4) Stud Wall