Table of Contents
Advertisement
•
Fit the blade.
CAUTION! The blade has a groove (A) on one side that
acts a the guide groove for the support rollers. Ensure that
the V-shaped edge of the blade enters the drive wheel and
that the blade's guide groove fits in the guide rollers. Also
see under the heading Drive.
•
Press in the guide roller if necessary, so that it climbs into
the groove on the blade.
•
Fit the support roller cover. Now tighten the four screws
fully.
•
Rotate the blade and make sure that the support rollers
are not clamped against the blade.
•
Adjust the adjuster screws so that the support rollers
make contact against the blade.
SETTINGS AND ADJUSTMENTS
•
Adjust so you can easily stop the support rollers using
your thumb when the blade is rotated. The support rollers
should only follow the blade occasionally.
•
Tighten the locking nuts on the support roller guard.
•
Rotate the blade and make sure you can still hold the
rollers with your thumb when the blade is rotated.
CAUTION! The machine should be upright. If the machine
lies on its side the weight of the blade makes it difficult to
make a correct adjustment.
•
Tighten the knobs fully and the machine is ready to use.
– 13
English
Advertisement
Table of Contents
