GE RGA620 Owner's Manual And Installation Instructions page 27

Read these instructions completely and carefully.
WARNING!
Anti-Tip Bracket
Anti-Tip Bracket Installation Instructions
Anti-tip bracket attaches to the floor to hold either rear
range leg. When fastening to the floor, be sure that the
screws do not penetrate electrical wiring or plumbing. If
you cannot be sure of this, use shorter screws that will not
penetrate through the flooring.
If the anti-tip device supplied with the range does not fit
the application, use the universal anti-tip device
WB02X7909.
Decide whether the anti-tip bracket will be
installed on the right or left side of the
range location.
If the bracket side of the range is next to a
cabinet or wall, place the bracket 1
the cabinet or wall.
If there is no adjacent cabinet, determine
where the location of the range side
(painted outside panel) will be. Place the
bracket so that the distance between the
mounting holes (center line) is 1
the side panel. Position the bracket so the
back hole is 2
Adjacent cabinet
or wall
• ALL RANGES CAN TIP
• INJURY COULD RESULT
• INSTALL ANTI-TIP DEVICE
PACKED WITH RANGE
• SEE INSTRUCTIONS
3
" from the back wall.
7 ⁄
1 6
Wall behind
range
"
1 ⁄
9
16
Screw the bracket securely to the floor
with the screws provided. The screws are
self-drilling in wood, plywood, particle and
chip board, and most metal framing. If
attaching to masonry, you can buy suitable
screws and/or anchors at hardware stores.
Use a masonry drill to drill the required
holes.
" from
9 ⁄
1 6
Using your hand or channel-lock pliers,
back out the four range legs at least two
" from
turns. Level the range. See the Protect Your
⁄
8
Floor and Leveling the Range information in
these Installation Instructions for leveling
information.
Slide the range into place.
"
2 ⁄
7
16
Anti-tip
Wall
bracket 2
"
7 ⁄
16
27