HP COMPAQ 6005 Quickspecs page 18

QuickSpecs
Technical Specifications - Audio
High Definition Audio Type
High Definition Stereo
Codec
Audio Jacks
NOTES:
Internal Speaker Amplifier is for Internal Speaker only. External Speakers need to be powered
externally.
The rear input port can function as a Line-In or Microphone-In jack.
The front Microphone jack is retaskable to support headphones. When functioning as a
headphone jack the same audio stream will be sent to both front jacks.
The front Microphone jack is also retaskable to function as a Line-in jack.
The Realtek Control Panel software required to reassign audio ports is preloaded but must be
installed by the customer before these functions can be performed.
Multistreaming
Capable
Sampling
Wavetable Syntheses
(software)
Analog Audio
Number of Channels
on Line-Out
(mono/stereo)
Internal Audio Speaker
Power Rating
Internal Speaker
External Speaker Jack
(Line-Out)
DA - 13412 Worldwide QuickSpecs — Version 6 — 10/14/2009
Integrated
Yes – 4-channel Realtek ALC261 codec
Front microphone-In (150-K ohm Input Impedance)
Rear Line-In/Microphone input (150-K ohm Input Impedance, function is
configurable by audio driver)
Rear Line-Out* (190 ohms Output Impedance, expects at least a 10-K
ohm load)
Front Headphone-Out (0.5 Ohm Output Impedance, expects at least a
32 ohm load)
Multistreaming can be enabled in the Realtek control panel to allow
independent audio streams to be sent to/from the front and rear jacks.
8 kHz – 192 kHz
Yes – Uses OS soft wavetable
Yes
Stereo (Left & Right channels)
1.5 W
Yes; ability to mute internal speaker through F10 Setup
Yes
HP Compaq 6005 Pro Business PC
Page 18