Connecting Wr-1 Units - Nikon WR-1 User Manual

Connecting WR-1 Units

Connecting WR-1 Units
Connect the units to the cameras they will be used to control.
1
Open the ten-pin terminal cover.
Open the terminal cover as shown.
2 Connect the supplied ten-pin or accessory terminal cable.
Use the supplied MC-37 cable when connect-
ing receivers to cameras with ten-pin remote
terminals, the MC-38 when connecting re-
ceivers to cameras with accessory terminals.
Keeping the 1 mark on the cable's ten-pin
connector aligned with the white w mark
next to the ten-pin terminal, insert the connector as shown and
tighten the screw to lock it in place.
3
Connect the cable to the camera.
If the camera is equipped with a ten-pin re-
mote terminal, align the 1 mark on the
MC-37 connector with the white w mark next
to the camera ten-pin remote terminal and
insert the connector as shown. Tighten the
screw to lock the cable in place.
If the camera is equipped with an accessory
terminal, align the 1 mark on the MC-38 con-
nector with the 1 mark next to the camera
accessory terminal and insert the connector
as shown.
6
Ten-pin terminal