Gesytec Easylon User Manual page 9

+
Router
 LON and LON/IP: During the router's initial phase those LEDs remain
 Start / Reset: This LED glows green while the router is launched. During
 Ethernet: The RJ45 connector includes a green and a yellow LED. As
Buttons
Furthermore the device is provided with two buttons:
 Service: By pushing this button, service pin messages are sent out on
 Factory Reset: This button sets the device back to the factory settings, as
Via the DIL switches a topology dependent bus termination can be set for the
LON/FT segment:
 Free / Bus: With the right switch of the block you specify if a termina-
 ON / OFF: The termination itself is switched "Off" and "On" by turning-
Always switch over both left termination switches, which means they always
have to be set to OFF or ON together, but never oppositional.
2
This may be caused by missing Ethernet connection or a duplicate IP address may have been assigned.
If the device has no IP address
green, if its base state is already red due to another condition).
disabled. The LEDs flicker during operation if data are transmitted via
the respective channel. In case of overload of a channel the appropriate
LED glows red for one second while the status LED is continuously set
to red.
a Factory Reset the LED gives different signals, cf. chap. 6.4.
When the router is running, this LED also shows the connection state to
the Configuration Server: LED on = connected to Configuration Server.
soon as a connection between an IP network has been established, the
green LED is glowing. While transmitting data packets, the green LED
flickers. The yellow LED indicates the connection speed. Is this LED il-
luminated, the speed is 100 Mbit/s, otherwise 10 Mbit/s.
both LON interfaces and the LON and LON/IP LEDs give a are short
signal.
described in chapter 6.4.
tion is to be switched for free topology "Free" ( 50 Ohm) or for a bus
topology "Bus" ( 110 Ohm).
over both left switches.
About Easylon Router+
2
the LED is flashing periodically red (or
5