Sony DSR-1800 Operating Instructions Manual page 69

VIDEO CONTROL [Video]: Settings related to video control Description of settings
WIDE MODE [>Wide mode]: Determine whether to retain
wide-screen aspect ratio information accompanying video
being recorded or played back.
ESR MODE [>ESR mode]: Select whether to enable the edge
subcarrier reducer (ESR).
PROCESS CONTROL [>Proc
ctrl]
(For DSR-1800P only)
INPUT BLANK [>Input blnk]
AUDIO CONTROL [Audio]: Settings related to audio
control
REC MODE [>REC mode]: Select the audio recording mode.
CONTROL DEV [>>Ctrl
dev]: Select the
method of controlling
the internal digital
video processor.
C PHASE MODE [>>C
Phas MD]: Select the
phase rotation mode
for chroma phase
control.
The effect of this setting
applies to the output levels
of all of the composite
video, S video, SDI and
component video signals.
ADJ RANGE [>>Adj
range]: Select the
variable range of the
VIDEO and CHROMA
gains.
VIDEO GAIN [>>V gain]:
Adjust the video output
level.
CHROMA GAIN [>>C
gain]: Adjust the
chroma output level.
CHROMA PHASE [>>C
phase]: Adjust the
chroma phase.
(For DSR-1800 only)
SETUP LEVEL [>>Setup
lev]: Adjust the black
setup level.
(For DSR-1800P only)
BLACK LEVEL [>>Black
lev]: Adjust the black
level.
LINE 335 [>>Line 335]:
Switch blanking on or
off for the 335th line of
the input video signal.
*AUTO [>> Auto]: When video being recorded or played back
is accompanied by wide-screen aspect ratio information,
retain the information.
OFF [>> OFF]: Ignore wide-screen aspect ratio information.
ON [>> ON]: Whenever recording or playing back video, retain
wide-screen aspect ratio information.
*OFF [>> OFF]: Do not enable.
ON [>> ON]: Enable.
When playing back a composite signal, set this to ON.
*REMOTE [>>>REMOTE]: Use the optional UVR-60/60P or
BVR-50/50P Remote Control Unit to remote control the
internal digital video processor.
MENU [>>> MENU]: Use the setup menu to change the
settings for the internal digital video processor.
*U/V (COMPOSITE) [>>> Cmpst]: Select this setting when
observing the composite video output level using a
composite vectorscope.
PB/PR (COMPONENT) [>>> Cmpnt]: Select this setting
when observing the component video output level using a
component vectorscope.
*− − − − 3 to + + + + 3 (dB) [>>> − − − − 3/+ + + + 3]: −3 dB to +3 dB
WIDE [>>> wide]: −∞ to +3 dB
00H to 3FFH
Factory default setting: 200H
00H to 3FFH
Factory default setting: 200H
00H to FFH
Factory default setting: 80H
00H to 3FFH
Factory default setting: 200H
00H to 3FFH
Factory default setting: 200H
BLANK [>>> blank]: Blank.
THROUGH [>>> through]: Do not blank.
Description of settings
*2CHANNEL (48kHz) [>> 2 ch]: 2-channel, 48-kHz mode
4CHANNEL (32kHz) [>> 4 ch]: 4-channel, 32-kHz mode
69
Menu Contents