IES Series Industrial Ethernet Switch User Guide Model: IES-2205, IES-2206, IES-2208, IES-2216, IES-2210, IES-2220 July, 2011 Version:1.0 IES Series User Manual V. 1.0...
L-com Global Connectivity reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult L-com Global Connectivity to determine whether any such changes have been made. The hardware, firmware, or software described in this document is subject to change without notice.
Page 3
SAFETY PROVISIONS Please read this user manual thoroughly before installing the IES switch Do not place equipment in or around water Keep power line connections clear Do not let power lines touch or contact each other Verify power requirements of all attached devices prior to installation ...
Auto connection with MDI/MDI-X • 100Base-FX Full duplex Single mode or Multimode fiber options • Broadcast Storm Protection • Redundant 24V DC power inputs (except IES-2205) • Reliable protection from EMC and against over-current / over-voltage. • Ribbed heat-removal case design •...
Input expend: IES-2205, IES-2206, IES-2208 <5W Power parameters IES-2210, IES-2216, IES-2220 <15W Voltage passing:Inside IES-2205 1.30” W x 3.17” D x 4.5”H IES-2208, IES-2206 Series 1.30” W x 3.85” D x 5.7”H Dimensions IES-2210 Series 2.13”W X 4.35”D x 5.70”H IES-2216, IES-2220 Series 2.84”W x 4.33”D x 5.70”H...
L-com’s IES series. See figure 2-1. Fig. 2-1 2.1.2 Power Input Interface and Installation Power Terminal Block The IES-2205 features a single 24V DC power input with one V+ power anode and one V- power cathode. Figure 2-2. IES Series User Manual V. 1.0...
Fig. 2-2 The IES-2206, IES-2208, IES-2216, IES-2210, and IES-2220 all feature redundant power connectors with dual power anodes and V- power cathodes. See Figure 2-3. Fig. 2-3 When using only one power supply make sure to connect the supply to the V1+ and V1- terminals. Power conductor diameter should be less than 1.5mm to fit the screw terminals.
To connect power to the switch first make sure the AC/DC power supply is NOT connected to an AC power outlet. Connect the + and – conductors from the AC/DC power supply to the V1+ and V1- terminals respectively. If a redundant DC power configuration is to be used connect the second set of conductors to V2+ and V2- respectively.
Chapter 3 Hardware installation 3.1 DIN-Rail installation Most industrial areas choose 35mm DIN-Rail installation. The DIN-Rail attachment plate is fixed to the rear panel of the IES Switch when you take it out of the box. If you need to reattach the plate to the switch, make sure the DIN-Rail bracket is situated towards the top.
Chapter 4 Support and Warranty 4.1 Support Should you require support for your IES switch please contact the L-com Product Support team via one of the following methods. __________________________________________________________________________________________ Phone 1-978-682-6936 Toll Free 1-800-341-5266 e-mail support@l-com.com 4.2 Warranty We warrant these IES Industrial Ethernet Switches for a period of three years from time of purchase. These products are warranted against defects in workmanship or materials under normal use.