Important Safety Information, Contents, Quick Help Table; Mains Supply - Altech PVR9600 User Manual

IMPORTANT SAFETY INFORMATION
9600
The PVR set top box meets applicable Australian and International Safety Standards.
Please read the following recommended safety precautions carefully before operating the product.

Mains Supply

The power pack is supplied with this set top box. It operates within the range
mains supply only. Connect the power cable to the set top box before connecting the other end
to the power outlet. Disconnect the set top box from the power outlet before connecting
or disconnecting the set top box from any other equipment. A well-regulated
for this unit to operate efficiently, contact Altech UEC for the recommended DC regulators.
Liquids and Spillage
Keep liquids away from the set top box and do not put anything on top of the set top box which may
spill (example: lit candles or containers of liquid). Do not use the set top box in extreme temperature
and humidity conditions.
Cleaning
Before cleaning the set top box, first disconnect the set top box from the mains. Use a dry cloth to clean
the exterior.
Ventilation and Installation
Do not block the ventilation holes and ensure that sufficient free airflow is maintained around the set
top box. Never stand the set top box on soft furnishings or on carpet. Do not use or store the set top
box near a heater or where it is exposed to direct sunlight. Never stack other heat generating electronic
equipment on top of, or below the set top box and always stand the product in a horizontal plain.
Servicing
Do not attempt to repair or modify the set top box yourself. Do not remove the top cover of the set top
box. Any tampering with the set top box will invalidate the warranty. Refer all servicing to Altech UEC
61 2 9425 5777
Australia, Tel. +
Lightning
If the set top box is installed in a location that is subject to extensive lightning activity, Altech UEC
recommends that a surge protection device is installed for the set top box mains supply.
Earthing
The earth/grounding system must comply with local regulations.
For assistance:
support@uec.com.au
www.uec.com.au
.
100-240 50-60
V AC Hz
12
V DC supply is essential
Page 4 of 52