To Change Configuration Parameters - HP E5200A User Manual

Setting Up the Analyzer
To Connect the Analyzer to a Computer
To Change Configuration Parameters
You can change the configuration parameters for the analyzer and the
controlling computer using either
To Configure the Analyzer Using the Network
Configuration Utility
1 Double click the HP Analyzer Terminal over SLIP icon in the HP
2 Switch on the analyzer and hold down the Enter key on the terminal
3 Type 2 to change the current boot parameters; then press Enter.
4 Record the configuration parameters for the analyzer.
5 Close the terminal window by pressing Ctrl-C.
6 Switch off the analyzer. You must reboot the analyzer after you have
7 Disconnect the terminal from the serial port.
8 Connect the analyzer to the network (see "To Connect the Analyzer as
1-20
the Network Configuration utility. Use this method of changing the
configuration parameters when you want to connect the analyzer as a
networked system. You must change the configuration parameters
before you connect the analyzer.
the analyzer system administration functions. Use this method when
the analyzer is connected as a standalone system.
Broadband Analyzer program group.
for five seconds until the HP Broadband Service Analyzer
Configuration menu appears. You must press the Enter key
immediately after turning on the power switch.
The keyboard on the remote workstation must be configured to auto-
repeat.
changed the configuration parameters.
a Networked System" on page 1-10).