Supported Qsfp/Sfp/Sfp+ Media Types; How To Connect Matrix To Your Network - Network Instruments Matrix User Manual

Operating 32° F (0° C) to 104° F (40° C)
Temperature
Humidity 35-85% (non-condensing)

Supported QSFP/SFP/SFP+ media types

Some products require an SFP module. These are the supported media types.
40 Gb QSFP Transceivers
40GBASE-SR4
10 Gb Ethernet SFP+ Transceivers
10GBASE-SR
10GBASE-LR
10GBASE-ER
1 Gb Ethernet SFP Transceivers
1000BASE-SX
1000BASE-LX
1000BASE-TX
License
IP Address
Default User/password
Self-signed certificate

How to connect Matrix to your network

Before you can configure or use the Matrix, you must complete the basic installation by connecting power
cables and inserting SFP modules.
1. Insert the two power cables (F).
2. Connect an RJ-45 Ethernet cable to the MGMT port (J).
3. Insert the SFP or SFP+ modules into the ports (C).
The device is pre-licensed at the factory. The license enables ports in blocks
of four starting at port 1. It also indicates the number of blocks that are 10 Gb-
capable. If you have eight ports licensed, you may only use ports 1-8. Ports 9-24
remain dark and unusable even if you insert an SFP module. If you need more
ports or blocks of 10 Gb, you can request a license upgrade.
192.168.1.10. Must use HTTPS in a web browser or SSH. HTTP will fail.
admin/admin
Network Instruments uses a
device, your web browser may issue a warning about the site being "untrusted"
or that there is a problem with the "security certificate." This is a harmless
message that may be ignored. You see that message because the site uses a
self-signed certificate. See your web browser's documentation for adding the IP
address as a trusted source.
Optical/Fiber Multimode or Single-mode
1 Gb (SX or LX)
10 Gb (SR, LR, ZR)
Copper 100/1000 Ethernet
self-signed certificate. When connecting to the
Supported QSFP/SFP/SFP+ media types | 9