Razor Ground force Drifter 25143400 Owner's Manual page 7

ASSEMBLY AND SET-UP
Turn power switch off before conducting any maintenance procedures.
Before you begin, carefully turn unit upside down for easier access.
q Removing Rear Axle
1
Using a 17mm open wrench
loosen locknut and remove rear
wheel located closest to the chain.
4
Remove c-clips on the axle
between the two bearings.
q Replacing the Chain
Master Link
Drive Direction
1
Locate the master link on the
replacement chain and with a
flat head screwdriver carefully
disengage the clip from the chain
to remove the link plate and
connector link.
2
Use a 3mm wrench to loosen
the brake.
5
Lightly tap the end of the axle
with a rubber mallet. DO NOT USE
A HAMMER as this will damage the
thread. The brake drum and pulley
must be slid along the axle as your
tapping progresses.
2
Wrap the chain around both
sprockets and tension idler. Insert
the connector link all the way
through the chain and fit the link
plate over the connector link.
3
Use a 3mm wrench to loosen the
sprocket.
6
When the axle end is clear of the
bearing hanger, remove the axle.
3
Using a flat head screwdriver,
carefully re-attach the clip on to the
link plate. The clip must point in the
drive direction of chain rotation.
6
Note: Chain should be periodically
checked for grime build-up. If
necessary remove any dirt and/or
debris in and around the chain and
re-lubricate with WD-40.
Master Link:
clip
secure clip
link plate
connector link