ASSEMBLY AND SET-UP
Turn power switch off before conducting any maintenance procedures.
q Adjusting the Brake
The brake lever is fitted with a cable adjuster to compensate for cable stretch and/or to fine tune the lever movement
to brake engagement.
1
To adjust the brake, thread the
adjuster in or out 1/4 to 1/2 turns
until the desired brake adjustment
is attained.
q Self Adjusting Chain Tensioner
Note: Proper alignment of the chain must be maintained. If the chain is adjusted properly, but is noisy or rough run-
ning, check alignment of the sprockets. The drive-shaft sprocket can be adjusted slightly from side-to-side by loosen-
ing the set screw. Note that a key maintains the drive position to the shaft.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
2
If the adjuster is threaded outward
and the brake still has too much slack,
use the auxiliary adjuster at the rear
brake for additional adjustments.
Note: When properly adjusted, the brake
lever will have approximately 3mm of
free play before the brake engages.
Motor shaft sprocket
Roller chain
Fixing bolt
Drive shaft sprocket
4
WARNING: Practice in
an open area free from obstacles
until you are familiar with the brake
function. DO NOT RUN OVER ANY
OBJECT AS IT COULD DAMAGE
THE BRAKE OR DRIVETRAIN.