Software Installation Procedure - HP 3C905B-TX Installation Manual

CAUTION
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide

Software Installation Procedure

Software Installation Procedure
Make sure that you have installed the network interface card before you
install the network driver software.
Software Installation on a Windows 95 System
This section describes how to install the network driver when your PC
is running Windows 95:
1 Start the PC.
Windows 95 will automatically detect the network interface card.
2 Select from the disk provided by the hardware manufacturer
Driver
and click on OK.
3 Insert EtherDisk diskette #2 in your drive, and if the diskette is in
drive A, click on OK.
Otherwise, supply the correct drive letter and then click on OK.
Once the 3Com installation files have been read, Windows 95
prompts you for the Windows 95 network installation files.
4 Enter the location of the Windows 95 files (CAB files), and click on
OK. On HP Windows 95 preloaded systems, the path is
C:\WINDOWS\OPTIONS\CABS.
If Windows prompts you to reboot, click on Yes. The driver
installation is complete.
Confirming Installation
Follow these steps to confirm that the network interface card is
properly installed in a PC running Windows 95:
1 Double-click on the
2 Double-click on the
3 Double-click on the
4 Click on the
Device Manager
type.
10 English
icon.
My Computer
icon.
Control Panel
icon. The
System System Properties
tab. A list of devices appears, arranged by
box appears.