Pride Mobility v10 Owner's Manual page 36

V10 series
Table of Contents

Advertisement

V I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into several
pieces: the seat, the front section, the rear section,
the battery shroud (if equipped), the basket, and
the batteries or battery boxes. See figure 20. No
tools are required to disassemble or assemble
your scooter, but keep in mind that the disassem-
bled sections of the scooter take up more floor
space than the assembled unit. Always disassem-
ble or assemble your scooter on a level, dry sur-
face with sufficient room for you to work and
move around your scooter–about 5 feet (1.5
meters) in all directions. Remember that some
scooter components are heavy and you may need
assistance when lifting them.
WARNING! Do not lift beyond
your physical capability. Ask for
assistance
while
disassembling
assembling your scooter.
1. Remove the seat by lifting it straight up and
off of the scooter. If you encounter resistance
when removing the seat, disengage the seat
rotation lever and swivel the seat back and
forth while lifting up on the seat.
2. Gently pull the battery shroud up and off of
the scooter.
3. Disconnect the battery tie-down strap.
4. Unplug both battery harnesses by pulling
each harness straight up. See figure 21.
5. Remove the batteries from the battery wells.
WARNING! Failure to unplug both
battery
harnesses
separating the front and rear
sections
permanent
scooter.
36
when
necessary
or
prior
to
could
result
in
damage
to
the
www.pridemobility.com
FRONT SECTION
BASKET
Figure 20. Scooter Components
BATTERY HARNESS CONNECTIONS
BATTERY TIE-DOWN STRAP
Figure 21. Harness Connections
SEAT
REAR SECTION
BATTERIES
BATTERY SHROUD
V10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc610vpsSc610vV10 ps

Table of Contents