Heat Sink And Fan - HP PROBOOK 4520S Maintenance And Service Manual

Heat sink and fan

NOTE:
Description
Heat sink for use in computers with UMA graphics subsystems
Heat sink for use in computers with discrete graphics subsystems
Before removing the heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
b.
Remove the heat sink:
●
For computers with discrete subsystem memory on the system board, follow these steps:
1.
Position the computer right-side up with the front toward you.
2. Following the sequence stamped into the heat sink, loosen the six captive screws (1), (2), (3),
(4), (5), (6), around the processor.
78 Chapter 4 Removal and replacement procedures
The heat sink spare part kit includes replacement thermal material.
Battery on page
Switch cover and keyboard (see
Thermal shield (see Thermal shield on page
55).
Switch cover and keyboard on page
67).
Spare part number
598676-001
598677-001
56).