Adjusting Trim Angle (Power Trim And Tilt) - Yamaha 50 Owner's Manual

1. Trim operating angle
EMU27885
Adjusting trim angle (Power trim and
tilt)
EWM00753
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the trim
angle. Body parts can be crushed be-
tween the motor and the clamp bracket
when the motor is trimmed or tilted.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt
G
switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
1
ZMU03109
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
UP
DN
1
1. Power trim and tilt switch
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
Operation
ZMU03110
UP
DOWN
ZMU03096
49