Table of Contents
Advertisement
Operating instructions
Read the EntiRE impORtant SaFEty inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
inspect tool before use, looking for damaged, loose, and missing parts.
if any problems are found, do not use tool until repaired.
tool Set up
tO pREVEnt SERiOuS injuRy FROm acciDEntal OpERatiOn:
turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
tO pREVEnt SERiOuS injuRy:
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. improper adjustment can result in tool failure or other serious hazards.
1. The Blade Guard (34) may be removed when
replacing blades (Items 36887 or 36888,
sold separately), but it must always be on
during operation. Using the Saw without the
Blade Guard can result in severe injury.
Blade
Blade Guard
Figure 1
2.
To remove the Blade Guard, use the Wrench
(31) to loosen the two Set Screws (24) on
the outside of the tool. When replacing the
Blade Guard, place it in the slots and tighten
the Set Screws (24). See Figure 1, above.
Chuck Cover
Figure 2
3.
To change blades, first open the Chuck Cover (26)
by removing the Screw (38). Swing the Chuck
Cover (26) back on its hinge. See Figure 2, above.
Page 10
Set Screw
Hex Wrench
Screw
For technical questions, please call 1-800-444-3353.
note: When Saw is in the upside down
position, the blade teeth will face upward.
Chuck Cover
Set Screw
Figure 3
Hex Wrench
4.
Loosen the two Set Screws (30) inside, until the blade
can be removed. Replace with a new blade (sold
separately) and tighten the Set Screws. Replace
the Chuck Cover and carefully tighten the Screw.
cautiOn: Do not overtighten the Screw or
you may break the plastic Chuck Cover.
Blade
Item 91753
Advertisement
Table of Contents
