Rear View Connections - Sceptre X405 User Manual

Rear View Connections

HEADPHONE – This connection is for headphones to be attached to the TV.
1.
USB – USB connects to USB flash drives for playing music and picture. The
2.
USB port is also used for updating the TV's firmware.
HDMI1-3 – HDMI connects to devices that use HDMI cable, such as Blu-ray
3.
or HD DVD player, or HD cable / satellite set-top box. This connection port
receives pure digital audio and high definition signal through one single cable.
This port also can accept a HDCP video device for video.
4. Audio In - This connection port is for people who want to provide audio to the
TV when using a PC or a DVI video device. The sources use 3.5mm mini-jack
audio cable.
5. VGA - This connection port connects to a PC for video using VGA cable. Be
sure to connect your audio cable to the VGA Stereo input if you want sound
out of VGA video source.
TV – This connection is for digital or analog cable without the cable box or
6.
over-the-airwave antennas. The tuner is a hybrid tuner that tunes to both
analog and digital channels. This connection uses coaxial RF cable. For
over-the airwave digital stations please check http://www.antennaweb.org.
7. SPDIF - This connection port is used for sending out digital audio signals to
digital surround sound receivers. The orange (COAX SPDIF OUT) connector
sends out either bit-stream or PCM digital sound signal to a home theater
receiver with digital coax input.
YPbPr – This connection port is for DVD players or satellite / cable set-top
8.
boxes that use component cables. From left to right, connect green, blue,
and red for video, and then connect white for left channel audio, and red for
right channel audio.
Video – Video connects to devices that use composite video cables such as
9.
VCR or DVD player or Wii™. Connect the yellow for video and the red / white
for audio.
10. Analog Audio Out – This connection is for connecting to analog audio
receivers.
Please Note:

This TV features a power saving function which will turn off the TV
automatically after 10 minutes of idling on a connection with no signal.
This feature is present on all connection.
- 12 -
www.SCEPTRE.com
SCEPTRE X405 HDTV User Manual