HP MINI 2102 Maintenance And Service Manual page 52

3. Remove the hard drive (4) by sliding it up and to the right at an angle.
4.
If it is necessary to replace the hard drive bracket, follow these steps:
a. Disconnect the cable adapter (1) from the hard drive.
b. Remove the four Phillips PM3.0×3.0 screws (2) that secure the hard drive bracket to the
drive.
c. Remove the hard drive bracket (3).
d. Remove the four rubber isolators (4) from the bracket.
Reverse this procedure to reassemble and install the hard drive.
44 Chapter 4 Removal and replacement procedures