Updating Parameters - Axis 5470e User Manual

237
AXIS 5470e/570/670e User's Manual Appendix A: SNA Parameter Overview

Updating parameters

This is most easily done from the internal web pages of your AXIS
5470e/570/670e. To set the parameters using a Web browser, you first
need to assign an IP address to the AXIS 5470e/570/670e. For
instructions on how to do this, refer to Assigning an IP address on
page 32.
Alternatively, you can update the parameters via FTP or by using
extended IBM printer emulation.
Using extended IBM printer emulation means setting up the AXIS
5470e/570/670e by printing a file containing extended IBM
emulation commands to it after you have established communication
with your IBM host. The configuration is started by inserting the
sequence in your text. To protect your settings, a password
%CONFIG+
must be provided. By default, the password is . You may then set
pass
the parameter values directly using the syntax shown below:
Syntax:
<Parameter name> = <value> [, <value>];
When all parameters have been set the command saves the
SAVE
settings permanently. The command resumes normal
%CONFIG-
printing. In order to maintain backward compatibility, some
parameters must be preceded by a command. See also
%CONFIG++
Appendix A The Parameter List on page 285.