Factory Defaults; Backup & Restore - TP-Link TL-WA730RE User Manual

Note:
1. There is no need to upgrade the firmware unless the new firmware has a new feature you want
to use. However, when experiencing problems caused by the device itself, you can try to
upgrade the firmware.
2. Before upgrading the device's firmware, you should write down some of your customized
settings to avoid losing important configuration settings of device.
To upgrade the device's firmware, follow these instructions:
1. Download a more
(http://www.tp-link.com).
2. Enter the path name or click Browse... to select the downloaded file on the computer into the
File blank.
3. Click Upgrade.
Note:
Do not turn off the device or press the Reset button while the firmware is being upgraded. The
device will reboot after the Upgrading has been finished.

4.9.6 Factory Defaults

Selecting System Tools > Factory Default allows you to restore the factory default settings for
the device on the screen shown in Figure 4-32.
Click Restore to reset all configuration settings to their default values.
•
Default User Name: admin
•
Default Password: admin
•
Default IP Address: 192.168.0.254
•
Default Subnet Mask: 255.255.255.0
Note:
Any settings you have saved will be lost when the default settings are restored.
4.9.7 Backup & Restore
Selecting System Tools > Backup & Restore allows you to save all configuration settings to your
local computer as a file or restore the device's configuration on the screen shown in Figure 4-33.
TL-WA730RE 150Mbps Wireless N Range Extender User Guide
recent firmware
Figure 4-32 Restore Factory Defaults
44
upgrade file from the TP-LINK website