Control Functions - Snapper 5900859 Operator's Manual

Control Functions

The information below briefly describes the function of individual controls. Starting, stopping, driving, and
mowing require the combined use of several controls applied in specific sequences. To learn what combination
and sequence of controls to use for various tasks see the OPERATION section.
Throttle Control
The throttle controls engine speed. Move the
throttle forward to increase engine speed and back
to decrease engine speed. Always operate at FULL
throttle.
Choke
Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not
require choking. Pull the knob UP to close the choke.
Push to knob DOWN to open the choke.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Features & Controls
Deck Transport Adjustment
Handle, Cutting Height Adjustment Handle
& Deck Lift Lock Lever
These control the cutting height of the mower deck:
Cutting Height Adjustment Handle: Turn the cutting
height adjustment handle CLOCKWISE to raise the
cutting height of the mower; COUNTER-CLOCKWISE
to lower the cutting height of the mower.
Deck Transport Adjustment Handle & Deck
Lift Lock Lever: Pull the deck transport handle
adjustment backwards and up until it latches into
place to raise the cutter deck to the TRANSPORT
position. To lower the cutter deck to the OPERATION
position, release the deck lift lock lever and push the
deck transport handle forward and down.
11