Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
1
To clean the LCD monitor screen:
•
Turn off the LCD monitor and unplug the power cord.
•
Spray a non-solvent cleaning solution onto a rag and clean the screen gently.
2
Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.
3
Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
4
Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of
any nature.
5
Store the LCD monitor in a room with a temperature of -20° to 60° C (-4° to140° F). Storing the LCD monitor outside this
range may result in permanent damage.
6
Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:
•
Monitor-to-PC signal cable is frayed or damaged.
•
Liquid spills onto the LCD monitor or the monitor is exposed to rain.
•
The LCD monitor or case is damaged.
Package contents
Quick
LCD
User
start
monitor
guide
guide
Adjusting the monitor base
1
Carefully remove the monitor from its packaging.
•
The monitor base is attached onto the monitor before shipment and it is undetachable.
2
Pull the monitor base out fully so that the monitor can be placed on a stable surface in the upright position.
3
Secure the monitor base by turning the white screws (at the bottom of the base) using the integrated tab or a suitable coin.
Connecting your monitor to a computer
1
Turn off your computer and unplug your computer's power cord.
2
Connect the signal cable to the VGA and/or DVI-D (optional) and/or
HDMI input socket of the monitor, and the VGA and/or DVI-D (optional)
and/or HDMI output socket of the graphics card on the computer.
or connect MHL cable(Only for MHL-Input Model)(Optional) to the
portable device.Then tighten the thumbscrews on the signal cable
connector.
3
Connect one end of the adapter to the monitor and the other end to a
properly grounded, AC outlet.
4
Plug the power cords of your computer and your monitor into a nearby
electrical outlet.
5
Connect the audio cable.
Connect an audio cable to the audio port of the monitor.
Note: MHL input only works for the MHL-certified device. Please chek
user manual for more instruction.
Panel controls
No.
Item
Description
1
Power button/
Turns the monitor on/off. Blue indicates power
indicator
on. Orange indicates standby/power saving
mode.
<
>
2
/
button
Press the
function or to change the settings of the current
function.
3
Menu/Enter
Press to view the OSD menu. Press it again to
button
enter a selection in the OSD menu.
4
Auto/Exit button
• When the OSD menu is active, press this
• When the OSD menu is inactive, press
5
Empowering
Press this button to open the Acer eColor
Key
Management OSD and access the scenario modes.
VGA
AC
cable
Adapter
<
>
/
button to navigate to the desired
button to exit the OSD menu.
this button to activate the Auto Adjustment
function.
AC
HDMI
DVI cable
Power
cable
(Optional)
cord
(Optional)
VGA
H D M I
HDMI 1
(MHL)
HDMI 1
5
Audio
MHL
cable
cable
(Optional)
(Optional)
HDMI 1
HDMI 2
VGA IN
AUDIO IN
DC IN
H D M I
VGA
DC
HDMI
VGA
AUDIO
HDMI 2
VGA IN
AUDIO IN
DC IN
(MHL)
VGA IN
AUDIO IN
DC IN
HDMI 2
4
3
2
1