A03-HP1001 / A03-HP1501 / A03-HP2001 / A03-HP3001
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety instructions. Please follow all instructions carefully during installation. Read this
manual thoroughly before attempting to unpack, install or operate.
CAUTION:
To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area,
free of conductive contaminants.
CAUTION:
Risk of electric shock, do not remove the cover. No user
serviceable parts. Refer servicing to qualified service personnel.
CAUTION:
Risk of electric shock, hazardous live parts inside this UPS can be
energized from the battery supply even when the input AC power is
disconnected.
CAUTION:
Risk of electric shock, Battery Circuit is not isolated from AC input;
hazardous voltage may exist between battery terminals and
ground. Test before touching.
WARNING:
This is a Class A-UPS Product. In a domestic environment, this
product may cause radio interference, in which case, the user may
be required to take additional measures.
NOTICE:
The UPS is designed to be for use with computer loads only.
NOTICE:
To prevent injury, do not carry with the handle of front cover when
moving the UPS.
1 Inspection
Inspect the UPS upon receipt. Notify the carrier
and dealer if there is damage. The package is
recyclable; save it for reuse or dispose of it
properly.
2 Place the UPS properly
5 Connect Network
Surge protection
Connect a 10 base-T / 100 base-T network cable
into the RJ-45 network surge protection "IN" jack
on the rear of the UPS. Connect from the "OUT"
jack with network cabling to network equipment.
IN
O U T
USER'S MANUAL
SAVE THESE INSTRUCTIONS
SETUP
3 Connect the loads
First, connect the UPS with Utility, then plug the
loads into the outlets on the rear of the UPS. To
use the UPS as a master "On/Off" switch, make
sure that all of the loads are switch "On".
These UPS outlets provide battery power and
surge protection to the equipment when utility
voltage is outside acceptable limits.
Caution: Do not connect a laser printer to the
UPS outlets.
6 UPS Start Up
1. Connect the UPS to the wall receptacle.
2. Push the "On" Switch on the front panel of the UPS until 4 LEDs (LCD) are lit then extinguished
and release the "On" Switch.
3. The Backup mode LED (Amber) lights up and the UPS is under self-test mode now. If Utility is
normal, the UPS will run under Utility mode (Green LED) after its self-test is complete. On the
contrary, the UPS will run under Backup mode and the buzzer alarms every 2 seconds in case of
blackout or over/under voltage.
Caution:
1. The UPS "On" will not be executed if the above procedure is not done completely, which means
the button is released before all 4 LEDs (LCD) are extinguished.
2. The UPS will remain at "NO" output, if the start-up operation is not proceeded properly even
though the Input Power Cord is connected to the wall receptacle.
IMPORTANT NOTICE:
hours after initial installation.
4 Connect Computer
Interface Port
Connect the supplied interface cable (RS-232 or
USB) to the interface port on the rear of the UPS
and the computer interface port. See software
installation guide in the CD-ROM (Optional) for
installation purpose.
Plug the UPS into the wall receptacle to charge the UPS for over 10